1. Cosplay and 3D Printing

Slime Rancher VacPack

Read More
  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2021 SmugMug, Inc.
    The switch mounted in the underneath support.  I used some heat gun glue to hold it in place.  Then I printed a cross that fits in the same space on the other side to prevent it from being pushed in.
    Just a few more parts to print, and one day left to go...
    The handle is now in place.  Had to print it at a much lower resolution than I wanted.  After starting the print at the desired resolution, the end print time come up as 10/31 10pm... i.e. 4 hours after starting trick or treating...