1. Cosplay and 3D Printing

Slime Rancher VacPack

Read More
  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2023 SmugMug, Inc.
    Fitting the underneath support after the side dome has been put in place turned out to be rather tricky.  Even mounting the side dome wasn't working the way I had envisioned and I had to cut off some part of the lip that goes under the yellow flange.  After that, with some effort, I was able to fit the piece in
    Side view of the wirenest inside of the dome.
    I was being stingy with the support and one of them promptly tore off... tried to salvage the print with gaffers tape, but then when to double check my print and found one other issue with it.  Redid the slicing with a solid block of support covering all four holes and the rest of the overhang just to be save :)